Display Stand Assembly Instructions Video
Materials: Base, Support cubes, Bottom cover, Sides
Materials: Back wall, Top, Display billboard (warranty year will differ by store type – 1yr / 2yr)
Accessories:
- x2 hanging bars with price point display.
- Zip-tie + white circle.
- x2 Plexi base stands.
Top: Insert tabs into back and sides. Fold in center sides and tuck up gender to secure.
Display board: Fold sides back. Insert tabs on top while tucking the back folded sides in to secure.
Remove adhesive sticker on bottom and top of plexi stand.
*Large plexi in back placed standing tall with support bar facing out. Small plexi left front with slope angled down. Place Betta Bot onto while applying small pressure.
*Note: Smaller plexi will not fully apply to entire Betta (see photo). Insert hanging bar on side.
Insert zip tie to white circle and bring the zip tie end up through the hole on the base from underneath. Loop over the case bar and bring back down through the other hole. Connect zip tie to the other white circle hole, fasten zip tip and pull to secure. Cut excess zip tie.
